Denso Fuel Pump Rewiring
Instructions Page 3
2G FWD Turbo ('97 Spyder)
by Mark Purney
The wire may be tie-wrapped to
the main harness to keep it out of the way and protected.
Remove the side panel by the passenger's
right foot.
Remove the plastic trim which lines
the bottom of the door frame. This allows you to pull up the
carpeting and reveal the channel which you can run the wire
through.
Wire shown running through the
channel next to an existing hose.
Pull up the rubber moulding at
the back of the door frame.
Pull out on the plastic interior
panel (remove any screws first) just behind the door. You can
feed the wire through holes in the sheet metal panels and it
should come out on the other side near the fuel pump area.